DD15 Troubleshooting

Section 9.4 Improper Injector Calibration Setting

Section 9.4
Improper Injector Calibration Setting

Check as follows:‪

  1. Test for improper injector setting.
  2. Compare the calibration code(s) shown on the Detroit Diesel Diagnostic Link display with the six digit calibration code(s) on the injector(s).
    Click to see this graphic in a separate window
    1. If the calibration codes match, check compression pressure; refer to "9.5 Low Compression" .
    2. If the calibration code on the display is different then the calibration code on the suspect injector for that cylinder, the injector setting must be reset.


EPA07 DD15 Troubleshooting Guide - DDC-SVC-MAN-0029
Generated on 10-13-2008

Leave a Reply

Your email address will not be published. Required fields are marked *