DD15 Troubleshooting – Section 98.1 SPN 2797/FMI 3

Section 98.1
SPN 2797/FMI 3

This diagnosis is typically injector #1, 2, or 3 needle control valve circuit has a short to battery/power.‪

Check as follows:‪

1. Disconnect the Front Injector Harness 14–pin connector.
2. Turn the ignition ON (key ON, engine OFF).
3. Measure the voltage between pin 1 on the MCM side of the Front Injector Harness 14–pin connector and ground.
   1. If there is voltage present, repair the short to power between pin 1 of the Front Injector Harness 14–pin connector and pin 25 of the 120–pin MCM connector. Refer to "98.1.1 Verify Repairs" .
   2. If there is no voltage present, replace the under valve cover injector harness. Refer to "98.1.1 Verify Repairs" .

Section 98.1.1
Verify Repairs

Verify repairs as follows:‪

1. Turn ignition OFF.
2. Reconnect any electrical connections that were disconnected to perform the diagnosis.
3. Clear codes with DDDL 7.0 or latest version.

   ENGINE EXHAUST ‪
   To avoid injury from inhaling engine exhaust, always operate the engine in a well-ventilated area. Engine exhaust is toxic.‪

4. Start and bring engine up to operating temperature (over 140°F/60°C).
5. Verify operation is satisfactory and no warning lamps illuminate. If warning lamps illuminate, troubleshoot the codes. If assistance is required, call the Detroit Diesel Customer Support Center at 313–592–5800.