Series 40E – Section 11.4 Stopping

Section 11.4
Stopping

The following should be performed for NORMAL stopping:‪

  1. Release the load and decrease the "engine speed" in the NEUTRAL position.
  2. Allow the engine to run at idle with no-load for a few minutes, then turn the key switch to the OFF position.

The following should be performed for NORMAL stopping:‪

  1. Fill fuel tank. A full tank will minimize condensation.
  2. Check coolant level. Add coolant, if necessary, to bring it to the proper level.
  3. Check the oil level in the crankcase. Add oil, if necessary, to bring it to the proper level on the dipstick.
  4. Make a visual check for external leaks in the fuel, lubricating and cooling systems.

Section 11.4.1
Emergency Stopping

To stop the engine, turn the key to the OFF position.‪


Series 40E Service Manual - 6SE410
Generated on 10-13-2008

Leave a Reply

Your email address will not be published. Required fields are marked *