Series 50

Section 2.13 Electronic Foot Pedal Assembly

Section 2.13
Electronic Foot Pedal Assembly

The Electronic Foot Pedal Assembly (EFPA) connects the accelerator pedal to a Throttle Position Sensor (TPS). See Figure "Electronic Foot Pedal Assembly " . The TPS is a device that sends an electrical signal to the ECM. The signal varies in voltage according to the pressure on the pedal. The system is installed in the space normally occupied by the mechanical foot pedal. The EFPA has maximum and minimum stops that are built into the unit during manufacture.‪

Click to see this graphic in a separate window

Figure 1. Electronic Foot Pedal Assembly

Section 2.13.1
Repair or Replacement of Electronic Foot Pedal Assembly

The EFPA assembly is supplied by the vehicle manufacturer. Refer to the Original Equipment Manufacturer for service procedure.‪


Series 50 Service Manual - 6SE50
Generated on 10-13-2008

Leave a Reply

Your email address will not be published. Required fields are marked *