Series 50

Torque Specification Exceptions – Fasteners

Additional Information

SPECIFICATIONS

This section contains the exceptions to the fastener torque specifications.‪

Torque Specification Exceptions - Fasteners

The proper bolt and nut torque is dependent on its size. The proper torque for metric nuts and bolts are listed in Table "Class 10.9 Torque Specifications for Metric Fasteners" in the "General Information" section at the beginning of this manual. The exceptions to this rule are listed in Table "Exceptions - Metric Fastener Torque Specifications" . Standard (nonmetric) nut and bolt torque specifications are listed in Table "Standard (Customary) Fastener Torque Specifications" in the "General Information" section at the beginning of this manual.‪

EXCEPTIONS TO STANDARD FASTENER TORQUE SPECIFICATIONS

Bolt and Size, mm

Torque, N ·m

Torque, lb ·ft

M24 X 1.0‪

203-230‪

150-170‪

Table 1. Exceptions - Metric Fastener Torque Specifications

Note: The water pump drive gear retaining nut is M24 X 1.0.


Series 50 Service Manual - 6SE50
Generated on 10-13-2008

Leave a Reply

Your email address will not be published. Required fields are marked *