Series 50G & 60G Troubleshooting

Section 5.33 PID 173, FMI 4, Flash Code 82, Exhaust Temperature Sensor Input Voltage Low

Section 5.33
PID 173, FMI 4, Flash Code 82, Exhaust Temperature Sensor Input Voltage Low

The Exhaust Temperature Sensor input voltage is low due to a short.‪

Section 5.33.1
Troubleshooting PID 173, FMI 4, FLASH CODE 82

Troubleshoot as follows:‪

NOTICE:

To avoid damage to the harness and connectors when disconnecting harness connectors, ensure the pulling force is applied to the connectors and not to the wires extending from the connectors.‪

  1. Check wire 120 (tan, exhaust temperature) cavity R-2 in the 30–pin Engine Sensor Harness (ESH) connector for a short to ground (see Figure "Engine Sensor Harness 30–pin Connector" ). If there is a short, replace or repair wire(s).
    Click to see this graphic in a separate window

    Figure 1. Engine Sensor Harness 30–pin Connector

    1. If the code is still active, go to step .
    2. If the code is no longer active, refer to "5.33.2 Verification" .
  2. Check pin B (exhaust temperature) in the Exhaust Temperature Sensor connector. If there is a short, replace or repair the wire(s).
    1. If the code is still active, call Detroit Diesel Technical Service.
    2. If the code is no longer active, refer to "5.33.2 Verification" .

Section 5.33.2
Verification

Verify troubleshooting as follows: ‪

  1. Check the DDR to see if PID 173, FMI 4, Flash Code 82 is still active.
    1. If the code is still active, go to step 2.
    2. If the code is not active, troubleshooting is complete.
  2. If the code is still active, call Detroit Diesel Technical Service.


Series 50G and 60G Troubleshooting Guide - 6SE482
Generated on 10-13-2008

Leave a Reply

Your email address will not be published. Required fields are marked *