Series 60

Torque Specification Exceptions – Fasteners

Additional Information

SPECIFICATIONS

This section contains the exceptions to the fastener torque specifications.‪

Torque Specification Exceptions - Fasteners

The proper bolt and nut torque is dependent on its size. The proper torque for metric nuts and bolts are listed in Table "Class 10.9 Torque Specifications for Metric Fasteners" in the "General Information". Standard (nonmetric) nut and bolt torque specifications are listed in Table "Standard (Non-metric) Fastener Torque Specifications" in the "General Information" section. The exceptions to this rule are listed in Table "Exceptions - Metric Fastener Torque Specifications" .‪

Fastener

Torque, N · m

Torque, lb · ft

Bolt, Alternator Mounting Bracket‪

58-73‪

43-54‪

Nut, Drive Pulley‪

95-108‪

70-80‪

Bolt, Alternator-to-Mounting Bracket‪

81-95‪

60-70‪

Table 1. Exceptions - Metric Fastener Torque Specifications


Series 60 Service Manual - 6SE483
Generated on 10-13-2008

Leave a Reply

Your email address will not be published. Required fields are marked *