Series 60

Section 13.3 Engine Tune-Up Procedures for the Series 60G Engine

Section 13.3
Engine Tune-Up Procedures for the Series 60G Engine

The Series 60G engine is equipped with Detroit Diesel Electronic Controls (DDEC III/IV).‪

The tune-up procedure for the Series 60G engine consists of intake and exhaust valve clearance adjustments and spark plug replacement. These procedures should be performed with the engine cold. See Figure "Turbocharger Compressor Inlet Shield (Series 60G Engine)" for the gas turbocharger compressor inlet shield.‪

warning

PERSONAL INJURY

To avoid injury from accidental engine startup while servicing the engine, disconnect/disable the starting system.‪

warning

PERSONAL INJURY

To avoid injury from contact with rotating parts when an engine is operating with the air inlet piping removed, install an air inlet screen shield over the turbocharger air inlet. The shield prevents contact with rotating parts.‪

Click to see this graphic in a separate window

Figure 1. Turbocharger Compressor Inlet Shield (Series 60G Engine)


Series 60 Service Manual - 6SE483
Generated on 10-13-2008

Leave a Reply

Your email address will not be published. Required fields are marked *