Series 60

Section 16.6 Igniter Module Bracket

Section 16.6
Igniter Module Bracket

The igniter module gives off heat and must be mounted on the bracket to keep the internal temperature within acceptable limits. The igniter module bracket is made of aluminum to conduct heat from the igniter module.‪

Section 16.6.1
Removal of Igniter Module Bracket

Remove the igniter module bracket as follows:‪

  1. Disconnect the ignition coil harness from the igniter module.
  2. Remove the igniter module. Refer to "16.5.1 Removal of Igniter Module" .
  3. Remove the M10 x 1.5 x 30 mounting bolt.
  4. Inspect the igniter module bracket.
Section 16.6.1.1
Inspection of Igniter Module Bracket

Inspect the igniter module bracket as follows:‪

  1. Visually check the igniter module bracket for cracks and distortion.
    1. If damage is found, replace the igniter module bracket.
    2. If no damage is found, reuse the igniter module bracket.

Section 16.6.2
Installation of Igniter Module Bracket

Install the igniter module bracket as follows:‪

  1. Install the bracket to the cylinder head using M10 x 1.5 x 30 mounting bolt. Torque bolt to 58 - 73 N·m (43-54 lb·ft).
  2. Press the connectors of the ignition coil harness on the igniter module.


Series 60 Service Manual - 6SE483
Generated on 10-13-2008

Leave a Reply

Your email address will not be published. Required fields are marked *