Series 60 DDEC V Troubleshooting

Section 31.2 Troubleshooting Flash Code 26, SID 25, 61/FMI 11

Section 31.2
Troubleshooting Flash Code 26, SID 25, 61/FMI 11

The active switch input represents a low (grounded) external input circuit to the ECM/ECU.‪

The following procedure will troubleshoot Flash Code 26.‪

Section 31.2.1
Multiple Code Check

Perform the following steps to check for multiple codes.‪

  1. Turn ignition ON. Start and run the engine.
  2. Plug in diagnostic tool.
  3. Read active codes.
    1. If codes s 25/11 or s 61/11 are logged, refer to "31.2.2 Check Calibration Configuration" .
    2. If codes s 25/11 and s 61/11 are not logged, refer to "18.3 First Step for Diagnosing a Fault Within the DDEC System" .

Section 31.2.2
Check Calibration Configuration

Perform the following steps to check the calibration configuration:‪

  1. Select ECM/ECU input/output configuration.
  2. Determine cavity and wire number that is causing code to be logged.
  3. Select switch/light status.
  4. Determine status of that wire/cavity.
    1. If the switch reads OFF, refer to "31.2.3 Confirm Switch Status" .
    2. If the switch reads ON, the OEM supplied switch/relay is grounding the wire or a short to ground exists. Determine OEM supplied device or repair the short. Refer to "31.2.3.1 Verify Repairs" .
    3. If no OEM device is used, remove the wire from the connector and plug, or use programming station to disable the function.

Section 31.2.3
Confirm Switch Status

Perform the following steps to confirm switch status:‪

  1. Start and run the engine for one minute.
  2. Again, read switch status.
    1. If the switch reads OFF, the condition no longer exists. Contact the OEM to learn which item is wired to this cavity. Refer to "31.2.3.1 Verify Repairs" .
    2. If the switch reads ON, the OEM supplied device is grounding this wire. Contact the OEM for repair procedure. Refer to "31.2.3.1 Verify Repairs" .
Section 31.2.3.1
Verify Repairs

Perform the following steps to verify repairs:‪

  1. Turn ignition ON.
  2. Clear codes with diagnostic tool.
  3. Note status of CEL/AWL/SEL/RSL.
  4. If the CEL/AWL/SEL/RSL are not on, start and run the engine for one minute.
  5. Read active and inactive codes.
    1. If no codes are logged, troubleshooting is complete.
    2. If codes 25 or 61/11 and any other codes are logged, all system diagnostics are complete. Review this section from the first step to find the error. Refer to "31.2.1 Multiple Code Check" .
    3. If codes 25 or 61/11 are not logged, but other codes are logged, refer to "18.3 First Step for Diagnosing a Fault Within the DDEC System" .


Series 60 DDEC V Troubleshooting Guide - 6SE570
Generated on 10-13-2008

Leave a Reply

Your email address will not be published. Required fields are marked *