Section 8.5
Splicing Guidelines
The following are guidelines which may be used for splices. The methods described are not the only acceptable methods. Any method should produce a high quality, tight splice with durable insulation that can be expected to last the life of the vehicle.
The selection of crimpers and splice connectors is optional. Select a high quality crimper equivalent to the Kent-Moore tool, J 38706, and commercially available splice clips.
Section 8.5.1
Tools Required
The following is a list of tools required for splicing wires:
- Soldering iron
- Rosin core solder
- Wire strippers
- Heat shrink tubing
- Splice clips
- Crimp pliers
| DDEC III/IV Single ECM Troubleshooting Guide - 6SE497 |
| Generated on 10-13-2008 |