DDEC III/IV Single ECM Troubleshooting

Section 8.9 Multiple Broken Wires

Section 8.9
Multiple Broken Wires

To splice multiple broken wires:‪

  1. Stagger the position of each splice as illustrated. See Figure "Multiple Splices" .
  2. You must stagger positions to prevent a large bulge in the harness and to prevent the wires from chafing against each other.
    Click to see this graphic in a separate window

    Figure 1. Multiple Splices


DDEC III/IV Single ECM Troubleshooting Guide - 6SE497
Generated on 10-13-2008

Leave a Reply

Your email address will not be published. Required fields are marked *