Series 60 DDEC VI Troubleshooting – Section 4.9 Fuel Pump

Section 4.9
Fuel Pump

To determine if the fuel pump is causing starting difficulty, perform the following steps:‪

  1. Insert a piece of wire through the pump flange drain hole, see Figure "Fuel Pump Flange Drain Hole Location" .
    Click to see this graphic in a separate window

    Figure 1. Fuel Pump Flange Drain Hole Location

  2. Crank the engine momentarily and feel for wire vibration.
    1. If the wire did not vibrate, determine if the drive hub or coupling should be replaced; refer to "4.9.1 Drive Hubs and Coupling Replacement" .
    2. If the wire did vibrate, check for aerated fuel. Refer to "4.10 Aerated Fuel" .

Section 4.9.1
Drive Hubs and Coupling Replacement

Perform the following steps for drive hub or coupling replacement:‪

  1. Replace the drive hub or coupling; refer to the appropriate service manual, fuel system chapter.
  2. Test the engine to determine if starting has been improved; refer to " Engine Test with Replaced Drive Hubs or Replaced Coupling" .
Engine Test with Replaced Drive Hubs or Replaced Coupling

To determine if replaced drive hubs or coupling resolved starting difficulty, attempt to start and run the engine.‪

  1. If the engine starts and runs, no further troubleshooting is required. Shut down the engine.
  2. If the engine fails to start and run, check for aerated fuel; refer to "4.10 Aerated Fuel" .

EPA07 Series 60 DDEC VI Troubleshooting Guide - 6SE567
Generated on 10-13-2008

Leave a Reply

Your email address will not be published. Required fields are marked *