Series 60 DDEC V Troubleshooting

Section 5.3 Defective Starter

Section 5.3
Defective Starter

To determine if a defective starter is causing no start, perform the following steps:‪

  1. Place the red lead of a voltmeter to the solenoid "BAT'' or terminal; see Figure "Cranking Motor Available Voltage Test" .
    Click to see this graphic in a separate window

    1. Red Lead‪

    4. Black Lead‪

    2. Starter Ground‪

    5. Voltmeter‪

    3. Solenoid Terminal‪

    Figure 1. Cranking Motor Available Voltage Test

  2. Place the black voltmeter lead to the starter ground terminal; see Figure "Cranking Motor Available Voltage Test" .
  3. Engage the starter switch.
  4. View the voltage reading on the meter.
    1. If the voltage is less than specification (refer to OEM guidelines) while cranking the engine, starter replacement is necessary; refer to "5.3.1 Starter Replacement" .
    2. If the voltage is to specification (refer to OEM guidelines) while attempting to crank the engine, check for internal damage; refer to "5.4 Internal Engine Damage" .

Section 5.3.1
Starter Replacement

Perform the following steps for starter replacement:‪

  1. Replace the starter; refer to appropriate service manual, electrical equipment chapter.
  2. Verify replacement of starter; refer to "5.3.1.1 Test Engine with New Starter" .
Section 5.3.1.1
Test Engine with New Starter

To determine if the new starter resolved no start condition, attempt to start and run the engine.‪

  1. If the engine starts and runs, no further troubleshooting is required. Shut down the engine.
  2. If the engine fails to start or run, check for internal engine damage. Refer to "5.4 Internal Engine Damage" .


Series 60 DDEC V Troubleshooting Guide - 6SE570
Generated on 10-13-2008

Leave a Reply

Your email address will not be published. Required fields are marked *