Section 124.1 SPN 3662/FMI 6

Section 124.1
SPN 3662/FMI 6

This diagnosis is typically the Electronic Unit Pump Cylinder #4, Circuit Shorted to Battery.‪

Section 124.1.1
Circuit Shorted to Battery

Check as follows:‪

  1. Turn the ignition OFF.
  2. Disconnect the MCM 120 pin connector.
  3. Using the J-48475 breakout box and J-48583 overlay connect the MCM side of the harness ONLY.
  4. Turn the ignition ON.
  5. Measure the voltage between pin 4 of the J-48475 breakout box and ground.
    1. If voltage is greater than 0.5v, contact the Detroit Diesel Customer Support Center at 313–592–5800 for MCM replacement.
      Click to see this graphic in a separate window

      Figure 1. Electronic Unit Pump #4

    2. If no voltage is present, repair short to power between pin 4 of the MCM 120 pin connector and the #4 Electronic Unit Pump. See Figure "Electronic Unit Pump #4" .


EPA07 MBE 4000 DDEC VI Troubleshooting Guide - 6SE568
Generated on 10-13-2008

Leave a Reply

Your email address will not be published. Required fields are marked *