Series 60 – Torque Specification Exceptions – Fasteners

Additional Information

SPECIFICATIONS

This section contains the exceptions to the fastener torque specifications.‪

Torque Specification Exceptions - Fasteners

The proper bolt and nut torque is dependent on its size. The proper torque for metric nuts and bolts are listed in Table "Exhaust Valve Seat Inserts (Diesel)" in the "General Information" section at the beginning of this manual. The exceptions to this rule are listed in Table "Exceptions - Metric Fastener Torque Specifications" . Standard (nonmetric) nut and bolt torque specifications are listed in Table "Intake Valves (Diesel)" in the "General Information" section at the beginning of this manual.‪

EXCEPTIONS TO STANDARD FASTENER TORQUE SPECIFICATIONS

Bolt and Size, mm

Torque, N · m

Torque, lb · ft

M24 X 1.0‪

203-230‪

150-170‪

Table 1. Exceptions - Metric Fastener Torque Specifications

Note: The water pump drive gear retaining nut is M24 X 1.0.

warning

PERSONAL INJURY

To avoid injury from rotating belts and fans, do not remove and discard safety guards.‪


Series 60 Service Manual - 6SE483
Generated on 10-13-2008

Leave a Reply

Your email address will not be published. Required fields are marked *