MBE 900 – Section 10.4 EGR/Ca Mixer Housing

Section 10.4
EGR/Ca Mixer Housing

‪

Section 10.4.1
EGR/CA Mixer Housing Removal

‪

Remove the EGR/CA mixer housing as follows (see Figure "EGR/CA Mixer Housing Removal and Installation" for component locations):‪

1. Remove the charge air intake housing. Refer to "10.3.1 EGR Charge Air Intake Housing Removal" .
2. Remove the EGR/CA mixer housing cover bolts and remove the gasket and cover. Discard gasket.
3. Remove two hexagon socket-head head screws securing the EGR/CA mixer tube inside the charge air intake housing.
   

   1. Charge Air Intake Housing‪	5. Delivery Pipe‪
   2. EGR/CA Mixer Housing Cover Bolts‪	6. EGR/CA Mixer Tube‪
   3. EGR/CA Mixer Housing Cover‪	7. Hexagon Socket-head Screw‪
   4. Delivery Pipe Gasket‪	‪

   Figure 1. EGR/CA Mixer Housing Removal and Installation

Section 10.4.2
EGR/CA Mixer Housing Installation

‪

Install the EGR/CA mixer housing as follows (see Figure "EGR/CA Mixer Housing Removal and Installation" for component locations):‪

1. Install EGR/CA mixer tube in charge air intake housing with two hexagon socket-head screws. Tighten screws to 12–14 N·m (9–10 lb·ft).
2. Install charge air housing. Refer to "10.3.2 EGR Charge Air Intake Housing Installation" .