Section 122.1
SPN 3660/FMI 6
This diagnosis is typically the Electronic Unit Pump Cylinder #2 Circuit is Shorted to Battery.
Section 122.1.1
Circuit is Shorted to Battery
Check as follows:
- Turn ignition OFF.
- Disconnect the MCM 120-pin connector.
- Using the J-48475 Breakout Box and the J-48583 overlay, connect the MCM side of the harness ONLY.
- Run ignition ON.
- Measure the voltage between pin 10 of the J-48475
Breakout Box and ground.
- If voltage is greater than 0.5v, contact the Detroit Diesel Customer Support Center at 313–592–5800 for MCM replacement.
1.
2.
Figure 1. Electronic Unit Pump #2
- If voltage is present, repair the short to power between pin 10 of the MCM 120-pin connector and the # 2 Electronic Unit Pump. See Figure "Electronic Unit Pump #2" .
- If voltage is greater than 0.5v, contact the Detroit Diesel Customer Support Center at 313–592–5800 for MCM replacement.
EPA07 MBE 4000 DDEC VI Troubleshooting Guide - 6SE568 |
Generated on 10-13-2008 |