Section 26.3
SPN 100/FMI 4
This diagnosis is typically an Engine Oil Pressure Sensor circuit failed low.
Section 26.3.1
Failed Low Circuit Check
Check as follows:
- Turn the ignition ON (key On, engine OFF).
- Check for multiple codes:
- If 100/4, 94/4, 4407/4, 3609/4 and 3610/4 are present, repair the short to ground between pin 82 of the 120–pin MCM and the Engine Oil, Doser Fuel Line, Doser Fuel Compensation, DPF Inlet and DPF Outlet Pressure sensors. Refer to "26.3.1.1 Verify Repairs" .
- If 100/4, 94/4 and 4407/4 are present, repair the open between pin 82 of the 120–pin MCM connector and the Engine Oil, Doser Fuel Line and Doser Fuel Compensation Sensors. Refer to "26.3.1.1 Verify Repairs" .
- If only 100/4 is present, go to step 3 .
- Disconnect the Engine Oil Pressure Sensor.
- Measure the voltage between pins 1 and 3 of the EOP Sensor harness connector. See Figure
"Engine Oil Pressure Sensor Wiring"
.
Figure 1. Engine Oil Pressure Sensor Wiring
- If the voltage is less than 4.5 volts, repair the open between pin 82 of the 120–pin MCM connector and pin 3 of the EOP Sensor harness connector. Refer to "26.3.1.1 Verify Repairs" .
- If the voltage is greater than 4.5 volts, go to step 5 .
- Turn the ignition OFF.
- Measure the resistance between pin 2 of the EOP Sensor harness connector and pin 54 of the 120–pin MCM connector.
- If the resistance is less than 5 Ω, repair the open between pin 2 of the EOP Sensor harness connector and pin 54 of the 120–pin MCM connector. Refer to "26.3.1.1 Verify Repairs" .
- If the resistance is greater than 5 Ω, repair the short to ground between pin 2 of the EOP Sensor harness connector and pin 54 of the 120–pin MCM connector. Refer to "26.3.1.1 Verify Repairs" .
Section 26.3.1.1
Verify Repairs
Verify repairs as follows:
- Turn ignition OFF.
- Reconnect any electrical connections that were disconnected to perform the diagnosis.
- Clear codes with DDDL 7.0 or latest version.
- Start and bring engine up to operating temperature (over 140°F/60°C).
- Verify operation is satisfactory and no warning lamps illuminate. If warning lamps illuminate, troubleshoot the codes. If assistance is required, call the Detroit Diesel Customer Support Center at 313–592–5800.
EPA07 Series 60 DDEC VI Troubleshooting Guide - 6SE567 |
Generated on 10-13-2008 |