Series 60 DDEC VI Troubleshooting – Section 27.2 SPN 103/FMI 1

Section 27.2
SPN 103/FMI 1

This diagnosis is typically turbocharger speed below threshold (High Box).‪

Section 27.2.1
Low Speed Check (High Box)

Check as follows:‪

  1. Inspect the entire air intake system for leaks and/or restrictions.
    1. If leaks or restrictions are found, repair as necessary. Refer to "27.2.1.1 Verify Repairs" .
    2. If no air intake system leaks or restrictions are found, go to step 2 .
  2. Connect to DDDL 7.0
  3. Turn the ignition ON (key On, engine OFF).
  4. Perform the DDDL Turbo Hysteresis Test.
    1. If the test passed, replace the Turbo Speed Sensor (TSS). Refer to "27.2.1.1 Verify Repairs" .
    2. If the test failed, refer to "6.5 Turbocharger (Diesel)" 6.5 in the Series 60 Service Manual (6SE2007).
Section 27.2.1.1
Verify Repairs

Verify repairs as follows:‪

  1. Turn ignition OFF.
  2. Reconnect any electrical connections that were disconnected to perform the diagnosis.
  3. Clear codes with DDDL 7.0 or latest version.
  4. Start and bring engine up to operating temperature (over 140°F/60°C).
  5. Verify operation is satisfactory and no warning lamps illuminate. If warning lamps illuminate, troubleshoot the codes. If assistance is required, call the Detroit Diesel Customer Support Center at 313–592–5800.


EPA07 Series 60 DDEC VI Troubleshooting Guide - 6SE567
Generated on 10-13-2008

Leave a Reply

Your email address will not be published. Required fields are marked *