Series 60 DDEC V Troubleshooting – Section 83.1 DDEC Pro-Link Operation

Section 83.1
DDEC Pro-Link Operation

The hand-held DDR/Pro-Link plugs into the Data Link Connector located in the Vehicle Interface Harness . This connection allows the DDR to receive data from the ECU. The DDR is used to display:‪

  • Engine Description via the ENGINE DATA LIST menu
  • Codes via the DIAGNOSTIC CODES menu
  • View/reprogram certain operating parameters

A printout of the information displayed on the DDR can be obtained by attaching a printer. ‪

Note: Suite 9 is required for DDEC V.

The following procedures will suggest several ways to use the Pro-Link on the DDEC system, see Figure "Pro-Link Plus/Diagnostic Data Reader Components" ,‪


Series 60 DDEC V Troubleshooting Guide - 6SE570
Generated on 10-13-2008

Leave a Reply

Your email address will not be published. Required fields are marked *