Series 60 DDEC V Troubleshooting – Section 83.3 Cylinder Cutout Sequence

Section 83.3
Cylinder Cutout Sequence

Start with the Menu Selection screen.‪

  1. Select ENGINE and ENTER.
  2. Go down and select FUEL INJECTOR INFO and ENTER.
  3. Go to CYLINDER CUTOUT and ENTER.
  4. Select NEW TEST and ENTER, or REVIEW LAST TEST and ENTER.
  5. Select IDLE and ENTER or 1000 RPM and ENTER.
  6. Select AUTO and ENTER, or MANUAL and ENTER three times.
  7. Test is now in progress.

Note: Test results stay stored in the Pro-Link memory as long as the DDR remains powered up.


Series 60 DDEC V Troubleshooting Guide - 6SE570
Generated on 10-13-2008

Leave a Reply

Your email address will not be published. Required fields are marked *