DDEC III/IV Single ECM Troubleshooting

Section 35.1 Description of Flash Code 35

Section 35.1
Description of Flash Code 35

Flash Code 35 indicates that the engine Oil Pressure Sensor (OPS), see Figure "Oil Pressure Sensor" , input to the ECM has exceeded 95% (normally > 4.75 volts) of the sensor supply voltage.‪

This diagnostic condition is typically:‪

  • Open sensor return circuit
  • Sensor signal circuit is shorted to the sensor +5 volt supply
  • Failed/damaged sensor


DDEC III/IV Single ECM Troubleshooting Guide - 6SE497
Generated on 10-13-2008

Leave a Reply

Your email address will not be published. Required fields are marked *