Series 60 DDEC V Troubleshooting

Section 83.5 Reprogram Calibration

Section 83.5
Reprogram Calibration

Start with the Menu Selection screen.‪

  1. Select ENGINE and ENTER.
  2. Down to CALIBRATION CHANGE and ENTER.
  3. Select REPROGRAM CAL and ENTER.
  4. Enter password: 0000 or xxxx and ENTER (xxxx=1 to 9 and A to Z).
  5. Select menu to be changed with UP/DN arrow keys and ENTER twice.
  6. Use RT/LT arrow keys to change a word or put in a new # and ENTER.
  7. When finished, select FUNC.
  8. SELECT ANOTHER MENU: left to YES and ENTER, or NO and ENTER.
  9. Left to YES and ENTER.
  10. Wait and then ENTER to continue.


Series 60 DDEC V Troubleshooting Guide - 6SE570
Generated on 10-13-2008

Leave a Reply

Your email address will not be published. Required fields are marked *