DDEC III/IV Single ECM Troubleshooting – Section 47.1 Description of Flash Code 47

Section 47.1
Description of Flash Code 47

Flash Code 47 indicates that the ECM has detected that the fuel pressure, air inlet pressure, or turbo boost pressure has exceeded a programmed operating range. This normally occurs due to a mechanical fault in the air system or fuel system of the engine. See Figure "Fuel Pressure Sensor " , for the fuel pressure sensor.‪

Note: Not all engines use a fuel pressure sensor.

For gas engines, code 47 indicates that the air inlet pressure has exceeded a calibration limit programmed in the ECM.‪

For diesel engines, code 47 indicates that the turbo boost pressure has exceeded a calibration limit programmed in the ECM.‪


DDEC III/IV Single ECM Troubleshooting Guide - 6SE497
Generated on 10-13-2008

Leave a Reply

Your email address will not be published. Required fields are marked *