Section 15.12
Ignition Boot Assembly
The boot assembly consists of the boot and spring and is serviced as an assembly.
Section 15.12.1
Removal of Ignition Boot
Remove the ignition boot as follows:
- Peel the end back from the coil and pull the two components apart.
Section 15.12.2
Installation of Ignition Boot
Install the ignition boot as follows:
- Secure the boot over the end of the coil.
Note: Ensure that the boot is all the way on the coil.
| Series 50 Service Manual - 6SE50 |
| Generated on 10-13-2008 |