Series 60 DDEC V Troubleshooting – Section 74.2 Troubleshooting Flash Code 82, PID 411/FMI 4

Section 74.2
Troubleshooting Flash Code 82, PID 411/FMI 4

The following procedure will troubleshoot Flash Code 82 p 411/4. ‪

For all EGR related codes, always perform the “Exhaust Gas Recirculation System Basic Checks.” Refer to "20.18 Exhaust Gas Recirculation System Basic Checks for Series 60 Engines" .‪

Section 74.2.1
Check EGR Delta-Pressure Sensor

Perform the following steps to check the EGR Delta-Pressure Sensor:‪

  1. Unplug the EGR Delta-P Sensor connector.
  2. Unplug the Engine Harness connector.
  3. Install a jumper wire between cavities 2 and 3 at the EGR Delta-Pressure Sensor: See Figure "EGR Pressure Sensor Wiring" .
    Click to see this graphic in a separate window

    Figure 1. EGR Pressure Sensor Wiring

  4. Measure resistance between cavities E-38 and E-15. See Figure "EGR Pressure Sensor Wiring" .
    1. If the resistance measurement is less than or equal to 5 Ω, Refer to "74.2.2 Check for Open" .
    2. If the resistance measurement is greater than 5 Ω, circuit E-38 or E-12 is open. Repair the open and refer to "74.2.2.1 Verify Repair" .

Section 74.2.2
Check for Open

Perform the following steps to check for an open. ‪

  1. Remove jumper cable.
  2. Measure resistance between cavities E-38 and E-15. See Figure "EGR Pressure Sensor Wiring" .
    1. If the resistance measurement is less than 5 Ω, E-38 is shorted to E-15. Repair short and refer to "74.2.2.1 Verify Repair" .
    2. If the resistance measurement is greater than 5 Ω, replace the sensor and refer to "74.2.2.1 Verify Repair" .
Section 74.2.2.1
Verify Repair

Perform the following steps to verify repairs for the EGR temperature or pressure sensor: ‪

  1. Connect all connectors.
  2. Start and run the engine.
  3. Road test the engine.
    1. If code 82 was not logged, no further troubleshooting is required.
    2. If code 82 was logged, please review this section from the first step to find the error. Refer to "74.2.1 Check EGR Delta-Pressure Sensor" . If this is the second time through the procedure, call the Detroit Diesel Customer Support Center (313–592–5800) or try a test ECM/ECU.


Series 60 DDEC V Troubleshooting Guide - 6SE570
Generated on 10-13-2008

Leave a Reply

Your email address will not be published. Required fields are marked *